GT86 Outer Tie Rods for MAX knuckles with stock LCA
SKU:ZNC6OTR
This OTR was created for allowing installation of our Super angle/roll center knuckle without the rest of the front end set for entry level drifters on a budget & grip drivers who are not interested in the additional steering angle the knuckle has to offer.
~ Measures 155mm or 6-1/8" from the joint center to the end which is about 15mm longer then OEM for full thread overlap.
~ The turnbuckle accepts ~45mm of m14p1.5 ITR thread length + ~10mm Jam nut = 56mm or about 2-1/4" ITR thread length desired for maximum ITR thread overlap
~ 6061 aluminum turnbuckle with gold anodizing and laser logos
~ CrMo PTFE lined m14 outer joint (standard misalignment type for the strength of the bearing race thickness)
~ Stainless Steel High misalignment top and bottom spacers adds 8 degrees of range.
~ Correct joint height is achieved with all larger OD spacers under the knuckle and above the joint which is required by our forged roll center/super angle knuckle.
*Not for use with the OEM tapered knuckle OTR mounting hole
Related Items
This OTR was created for allowing installation of our Super angle/roll center knuckle without the rest of the front end set for entry level drifters on a budget & grip drivers who are not interested in the additional steering angle the knuckle has to offer.
~ Measures 155mm or 6-1/8" from the joint center to the end which is about 15mm longer then OEM for full thread overlap.
~ The turnbuckle accepts ~45mm of m14p1.5 ITR thread length + ~10mm Jam nut = 56mm or about 2-1/4" ITR thread length desired for maximum ITR thread overlap
~ 6061 aluminum turnbuckle with gold anodizing and laser logos
~ CrMo PTFE lined m14 outer joint (standard misalignment type for the strength of the bearing race thickness)
~ Stainless Steel High misalignment top and bottom spacers adds 8 degrees of range.
~ Correct joint height is achieved with all larger OD spacers under the knuckle and above the joint which is required by our forged roll center/super angle knuckle.
*Not for use with the OEM tapered knuckle OTR mounting hole