Includes 2 44" lines with -3 female ends 1 -3 male to -4 male 1 -4 crush washer 1 -3AN to 3/8-24 Inverted Flare 1 -3 crush washer 2 90* -3 Swivel Female x -3 Male 1 10mmx1.0 I.F. female To -3 male 1 dash3 AN male to 10mm x 1.0 male Male M10 to -3 male goes to the OEM master's rear brake output and -3 steel braided line (which connects to the inlet on the end of the wilwood cylinder) Female m10 to -3 male goes to the oem brake line that you took out of the OEM master and -3 steel braided line (which connects to the outlet on the top of the wilwood cylinder) -3 male to 7/16-20 male goes to the larger fitting in the wilwood cylinder and -4 aluminum crush washer seals the connection -3 male to 3/8-24 male goes to the smaller wilwood cylinder fitting and -3 aluminum crush washer seals the connection 90 degree fittings both attach to the -3 side of the two above fittings and the other end to the braided lines. * Check out the installation diagram in the gallery!