FD3S Front Upper Arms for LimitBreak knuckle
This arm has an outer pivot point that is designed specifically for use with our forged Limitbreak knuckle to place the wheel on the center of the wheel well compensating for the knuckle's trailing spindle. Unique low profile shape gives maximum clearance for the inside of your wheel at full lock. It also has the extra length needed to compliment our knuckle's more vertical KPI versus the OEM setup. If you dont use this arm with our knuckle, you will get excess negative camber and the wheel will be swept to the rear. Spacer based camber/track width adjustment prevents any outer joint threads from being at risk of bending. Low torque PTFE lined spherical bearings and CrMo knuckle pin compliment this plate steel arm design that gives a proper width to compliment the LimitBreak front lower arm. Sold in Pairs, with a variety of hardware for adjustments. ***Install notes:***Some coilovers are thicker than others and may interfere where they pass through the center of these arms. Check for interference before driving the car. Different spring lengths, lower mount heights, or mounting positions may be needed. Curved side of arm meant to be positioned in the rear. Mounting tabs on the frame must be trimmed for clearance due to narrow arm design.